Blackbaud Europe Customers - SmartTPS Upgrade From 1.4.015 to 1.4.016 Deadline July 2013

Logic Group has released a new security patch for SmartTPS which includes new security certificates and must be in place on each till running SmartTPS by the beginning of July. After this point, the till will not be able to process transactions until the update is applied.  In order to ensure continued service please follow the install process below. If you have a brand new sales point or one that has never had SmartTPS installed, refer to Install Process 3.

Note: Before following these instructions, please ensure that you are logged in as a local administrator and be prepared for the system to reboot after installation.

Install Process 1:

1.  Log into The Patron Edge and run a start of day from SmartTPS administration.

2.  The update should be applied automatically and you will be advised the system is rebooting.

3.  After the system reboots, check the version number (instructions on how to check are at the foot of this post). If the version is 1.4.016, then the update has been successful, but if the version shows 1.4.015 please continue to Install Process 2.

Install Process 2:   

1. Download and run STPS-1.4.016-Patch on the till.

2.  After the system reboots, check the version number (instructions on how to check are at the foot of this post). If the version is 1.4.016, then the update has been successful, but if the version shows 1.4.015 please continue to Install Process 3.

Install Process 3:

Note: This process should be used for a brand new sales point or one that has never had SmartTPS installed OR if process 1 and 2 failed.

Download and run the Smart-TPSPoSKit-1.4.016 on the till.  This will set up SmartTPS version 1.4.016 for the first time or upgrade the current version.

How to check the SmartTPS version installed on your till:

Windows XP:
In Control Panel, Add/Remove Programs, highlight SmartTPS, and click Click here for support information. The version number will display in the Support info window.



Windows 7:
In Control Panel, Programs and Features highlight SmartTPS.  The version will display at the foot of the page:



If you have any problems with any of the instructions above, please contact david.martin@blackbaud.co.uk.